2016 New Products Multistage Impeller Solar Driven Water Pump

Basic Info

  • Model NO.: solar driven water pumps

  • Max.Capacity: >400 L/min

  • Material: Cast Iron

  • Assembly: Liquid Pumps

  • Start Up: Electric Pump

  • Application: Submersible Pump

  • Media: Clean Water

  • Theory: Centrifugal Pump

  • Capacity: 5-500m3/H

  • Outlet Diameter: 20-200mm

  • OEM: Ok

  • Trademark: MODO pump

  • Specification: Customerized

  • HS Code: 8413709990

  • Max.Head: >150m

  • Driving Type: Motor

  • Structure: Multistage Pump

  • Power: Electric

  • Type: Solar Power Water Fountain

  • Industry: Agriculture

  • Performance: No Leakage Pump

  • Model: Deep Well Drilling Pump

  • Head: 15-450m

  • Seal: Mechanical Seal

  • Warranty: 1 Year

  • Transport Package: Export Wooden Case

  • Origin: China

Product Description

2016 New Products Multistage Impeller Solar Driven Water Pump

1.Solar Driven Water Pump Working Parametres
(1). Flow range10~600m3/h,
(2). Lift scope within 5~600m;
(3). Caliber scope 32~203mm,
(4). Temperature range-15~80° C.
2.Introduction of Solar Driven Water Pump:
The solar water pump for agriculture is the high-tech production use the nature energy,saving time ,saving energy,saving labor.
There are two types solar system,DC series and AC series. About the DC water pump, It can direct connect PV panel.The AC solar water pump need connect with Inverter transfer power,then connect PV panel.The different power with different PV modules.
3.Use Conditions of Solar Driven Water Pump:
(1). 380 V bias voltage does not exceed -5% and 50 HZ frequency, and the deviation is not more than -1% of thethree-phase power supply.
(2). Electrical cavity must fill water.
(3). The first-class pump impeller should at least go into the dynamic water level 2 m below surface. Static pump unit immersed under water shall not be greater than 70 m.
(4). Electrical from the bottom of the bottom of the well shall be not less than 3 m.
(5). The water temperature no higher than 20 ° C, QJR-temperature hot water pump up to 80 ° C.
(6). Water and sand content (by mass) of not more than 0.01%.
(7). Water PH 6.5-8.5.
(8). The hydrogen sulfide in water content is not more than 1.5 mg / L.
(9). Water should ensure continued operation of the pump needs.
4.Structure Feature of Solar Water Pump for Agriculture:
(1). pump: The pump is installed on the upper part of the pump units.It's centrifugal and has water lubricated
a. bearing mounted with the motor shaft by a joint.
b. There is a check valve on top of the pump which could prevent rapaid inverse rotation from backword flow.
c. The pump unit should be immersed below the dynamic water lever when in using.
(2). motor: The motor is installed under the pump.
a. It is a water filled in hermatical structure.The stator windings are water-tight and PE insulating and multi-layers are covered with nylon.
b. The motor bearing is water-lubricated.The inner motor contains clean water to cool the water body and thebearing.
c. The rubber diaphgram adjusts the pressure change caused when temperature rises.
d. There is a sand resistance system in the upper part of the motor.
2014 hot sale solar system submasible 600w water lifting pump

Solar Pumps
Built-in MPPT Controller
? Wide working voltage:24v--540v.
? Built-in MPPT controller which can make the best use of solar energy.
? Over-voltage protection: The pump will stop working automatically when the voltage is over 96v; Then it will detect the voltage every 10 minutes, and it will start to work automatically when the voltage is between 38v and 96v.
? Under-voltage protection: The pump will stop working automatically when the voltage is under 96v; Then it will detect the voltage every 10 minutes, and it will start to work automatically when the voltage is between 38v and 96v.
? PS~ we can do higher head pump according to the customer's requirements.
? Note: the pump can not work without water. We will not offer warranty if the pump was damage for the reason of water shortage.

Hebei Chen Ming solar pool pump kit    
Stainless steel dc solar water pump supply, fountain,  solar system and all other field requires.This solar water pump has obvious advantages especially for those request high pump head and big power. It's a new generation electromechanical solar water pump200m head for agriculture.
Advantages of our solar pool pump kit
1. High efficiency, small size, light weight, more functions
2. MPPT function
3. Automatically working function
4. Work with both solar power and electricity, can connect with solar panels and AC electricity at same time, will use solar power in advance which is more higher efficient than MTTP function.
5. Do not need float switch, if there is no water in well for 1 minute, solar pump will stop working automatically. After 30 minutes, pump will start automatically power on to test whether there is water or not.
6. When power on the solar water pump 200m head, controller will detect the system of energy source to see it is solar panels or batteries, then start working. If there is solar power then use solar power, if no solar power will use batteries automatically.
Features of solar pool pump kit
1. High Energy Efficiency, motor efficiency is higher about 10-20% than common motors.
2. Small size, light weight
3. Multifunctions and Auto-protecting
4. AC/DC/SOLAR Energy multi power supplies
5. Constant speed synchronous operation, flow and head keep same
     #1  Newly developed DC Brushless Permanent-magnetic synchronous motor for solar pumps to get high speed and high efficiency.
     # 2 The pump's volume and weight is only 1/5 of other pumps with same specification, easy movement. 
     # 3  We acquired one invention patent and also have 11 patents for utility models and 3 patents abroad.
Solar water pump supply body: stainless steel 
Solar water pump 200m head motor body:stainless steel
Impeller:stainless steel
Solar Water Pump Appliction:
1.  Pasture irrigation
2.  Desertification control
3.  Fountain
4.  Domestic water
5.  Agriculture irrigation
6.  Desalination of sea water
7. Drinking water
8. Dripping irrigation
>>>solar pool pump kit working principle 
Q1: Are you a factory or a trading company?
A: Pump manufacturer.
Q2: What are your payment terms?
A: 30% deposit by T/T in advance, pay 70% balance when the products are finshed.
Q3: Can you do OEM?
A: Yes, we can. Any OEM are welcome!
Q4: How about the MOQ?
A: Sample order is also welcome! 
Q5: How about the delivery time?
A: Usualy, 2-15days. But it depends on your order quantity.
Q6: How about the warranty?
A: 3 year.
Q7: Why your price is higher than some suppliers?
A: We insist in ''Best quality, long-term cooperation", the motor parts for all our pumps are new 100% copper wire, the Specification of pump on lable is the TRUE and REAL DATA. For all pumps, we use is new material of every parts to ensure the pump's quality and long service life. Most of suppliers use old motor or remade material to make pump to lower the price, and the datd of their lable for pumps is not correct.

In order to recommend the suitable model, please inform us neccessory hereby :
Answer : before we answer your question, please inform us : how many m3 /hr water do you need? also inform us your requirement for distance for H1 =? , H2= ?, H3= ? , H4 = ? ;

Company Information
MODOPUMP can be also called solar water pump. Seniod solar pump makes use of the solar energy to pump, clean, no pollution, simple and convenient. It solves the problem of agriculture irrigation, people's and livestock's water supply and frontier defense sentry water supply in the region where there is no water and no electricity. This product can automatically work at sunrise and stop at sunset without manpower. It is
a high-technology green product with credibility and environment-protected. And systems are easy to install, PV pumping system can be connected to existing wells and pumps or installed quickly in new well. The technology is very easy for most wells and much deeper well to apply . Technical data: 1. Specification for A style: Max pump lift: 10M Max effluent: 80kg per hour Solar panel power supply: 12 watt Water pump voltage: 12 watt Mini/Max current:0.1A-0.8A Mini/Max voltage:16V-18V Size of pump: Diameter 5.2cm, length 36cm