The submerged slurry pump is a single-stage, single suction cantilever structure, which is connected with the hydraulic components of the pump by bearing seat, supporting seat and connecting pipe, and the liquid is discharged from the pump
The impeller of the slurry submerged pump is a semi open impeller, and a mixing blade is arranged at the inlet extension of the impeller blade. The main feature of the slurry submerged pump is that the pump shaft at the submerged part has sufficient rigidity. There is no bearing between the impeller and the pump shell, and the shaft seal is not used, so the medium with large concentration of fixed particles can be transported. The length of slurry submerged pump under liquid insertion is between 800-2000, and suction pipe can be equipped if necessary. The shaft seal uses a large slurry submerged pump to insert into the liquid for operation without shaft seal. The transmission is installed on the motor support and support seat by a vertical motor, and connected with the pump by a coupling.
On January 3rd,we got an inquiry from our Client Mr.A****K**** from Morocco
For the slurry submerged pumps:
Liquid: 65% water/35% ore (lead ore, copper ore, etc, size less than 3mm)
Submerged depth_m : maximum 2 meters
Capacity _m3/h : 15m3/h
Head_m : 10 m
Voltage&frequency : 220V/380V, 50Hz
We've to know that the pump would be used in Ore Mining Projects.Based on the specification ,we choose out suitable model,please check the slurry submerged pump photo as follows:
Assembly slurry submerged pump:(1) Install the bearing on the bearing box and bearing seat respectively.(2) Install the felt ring on the bearing end cover a, C and bearing box.（3） Install the bearing end covers B and C on the bearing seat and fasten them with bolts.(4) Put the bearing box with the bearing installed on the shaft, screw on the round nut, and fasten the bearing end cap on the bearing box.(5) Install the shaft into the bearing seat, fix it with bolts, screw on the adjusting screws, install the bearing on the support seat, and sleeve the water retaining ring at the proper position of the lower bearing.
(6) Fix the connecting pipe on the bearing seat, install the pump cover on the lower part of the connecting pipe, install the impeller on the lower part of the shaft and tighten it, install the front cover of the pump body in turn and fix it with bolts, adjust the clearance between the impeller and the front cover with the adjusting screw at the bearing box (controlled within 1-1.5mm), and fasten it with nuts and bolts after adjustment.
Not only slurry submerged,we supply the client horizontal slurry pumps.
Welcome your inquiry!We are pleased to work out the best solution for you!